This site requires javascript to be enabled to fuction correctly

What primary beam does CASA use for ALMA 12-m antennas? And what is the actual ALMA 12-m antenna primary beam, for that matter?
Posted by Brian Mason, Last modified by Fumi Egusa on 22 March 2017 12:41 AM

The voltage pattern assumed by CASA for the ALMA 12-m primary beam is currently hard coded to a uniformly illuminated 10.7-m dish with 0.75m blockage, resulting in an Airy disk whose FWHM is similar to a 12m Gaussian illumination with -12dB taper and 0.75m blockage. However its actual functional form will differand in particular the sidelobes will be higher than the real ALMA dish sidelobes are.

The actual ALMA antenna primary beam shape is a matter of active work, but the main lobe is reasonably well represented as having a FWHM of 1.13 lambda/d. This is what you would expect from a 12m with a Gaussian voltage illumination pattern that is tapered to -10 dB (rather than -12 dB as specified in design documents) that has a 0.75m blockage. The reasons for these discrepancies are under investigation.

See also Section "Single-dish Response" of the ALMA Technical Handbook.

Note that, at the time of writing, CASA truncates the beam at the 10% level regardless of whether a smaller value is requested with the minpb parameter in clean. This is a known bug that has been reported to the CASA development team.

Related Knowledgebase article:

(0 vote(s))
Not helpful

Comments (0)