This site requires javascript to be enabled to fuction correctly


Knowledgebase:
Why are the beam size value(s) in the Phase II OT different from the requested values in the "Control and Performance" tab?
Posted by Sarah Wood on 06 April 2018 06:00 PM

Since Cycle 5, the PI has had the ability to input a range of resolutions in the OT (a single value is considered a very tiny range).

Based on this information, the OT does the following in Phase II:


1) If the range is very narrow or a single value. It will widen it to a range +-20% around the center of the range or around the single value. This widening is performed to ensure a reasonable chance of schedulability.


2) Using either the AR range defined by the PI, or the one derived in step 1, it is checked whether the resolution of any nominal configuration falls within the range. IF NOT, then the range is extended in the direction of the closest nominal configuration resolution by +5% of that resolution (this extra tolerance is to further enhance the chances of schedulability when we are around that configuration).


3) For Cycle 6, if an SB can only be executed in C43-1 or C43-10, the lower or higher resolution in the range will be set 5% lower or higher than the nominal C43-1 or C43-10 resolutions, respectively. This, again is a safeguard for flexibility in scheduling. (For example, it covers the hypothetical case of the resolution request being right in exactly C43-1, but with the telescope operating with the blocker number of antennas (41), where the resolution would be just a bit coarser than C43-1, and the observation would not be scheduled.)


4) Also the resolutions are cropped if including long baseline configurations, or for optimizing combinations of configurations (this is also explained in the proposer's guide: "If the execution of a SG is time wise significantly more efficient in a subset of the allowed configurations, only that subset will be considered").

(0 vote(s))
Helpful
Not helpful

Comments (0)