This site requires javascript to be enabled to fuction correctly

Knowledgebase: Project Planning
How can I simulate observations with multiple configurations?
Posted by Adam Leroy, Last modified by Tristan Ashton on 16 October 2020 03:18 PM

The CASA simulation task simobserve simulates an observation based on a given antenna configuration, which is specified in the antenna position file. A user may wish to see the effect of combining data from two or more separate observations, taken with different configurations. Here we explain one way to go about it.

Each time simobserve is run, it produces a CASA measurement set. The measurement set has the file extension ".ms", and is in effect a calibrated u-v data set.

To simulate observations with multiple configurations, run simobserve separately for each configuration. You will thus produce a series of .ms files. You can then use the CASA task concat to concatenate these u-v data sets into a single, large .ms file. Next use the CASA task tclean to image this combined measurement set, just like any other u-v data.

Refer to CASA guide for simulations for more information.

Note: "tclean" can also accept multiple measurement sets, so the concatenation is largely for convenience.

(0 vote(s))
Not helpful

Comments (0)